|
PH-805-L ELITE™ Pommel Horse
Meets FIG
specifications for competition.• Accommodates FIG, USAG, NCAA
and
NFHS specifications• Rugged steel shell covered
with 7/10” (18mm) layer of cross-link polyethylene foam• Form
fitting cover of top grade leather• Heights adjustable from
37-1/2” to 53” (950 to 1350mm) in 50mm increments with smooth
action assist springs• Dual locking spin and snap lock
mechanisms• Non-marking floor contacts, one (1) with an
adjustable leveling foot• Finished in powder coated navy vien
407-098 ELITE™ Pommel Horse - Leather |
 |
|
Flat Top Pommels
One pair of
competition approved wooden flat top pommels for use on
American’s 800, 600, 300 and 200 series pommel horses.
407-036 Flat
Top Pommels – Pair (not shown) |
|
|
FIG Competition Pommel Horse Mat
This mat
meets FIG USAG, NCAA and NFHS specifications for competition.•
Core is a combination of 1-1/2” (3.75cm) polyethylene over
2-1/2” (6.25cm) polyurethane foam• Cover is 18 oz. knife coated
vinyl fabric• 4” (10cm) VELCRO® brand fasteners
416-166 FIG
Pommel Horse Mat System 16’ x 16’ x 4”
(4.9M x 4.9M x 10cm)
|
|
|
PH-605-T CLASSIC™ Pommel Horse
Meets FIG, USAG,
NCAA and NFHS specifications.
• Accommodates mats up to 10cm
• Rugged steel shell covered with 7/10” (18mm) layer of
cross-link polyethylene foam
• Form fitting cover of tapahide
• Heights adjustable from 37-1/2” to 53” (950 to 1350mm) in 50mm
increments with assist springs
• Dual locking spin and snap lock mechanisms
• Non-marking rubber floor contacts
• Finished in a classic blue powder coat
• A tie-down system is recommended because the base is lighter
than the 800 series.
406-100 CLASSIC™ Pommel Horse - Tapahide |
 |
|
CLM Competition Pommel Horse Mat
Meets the
requirements for USAG, NCAA and NFHS competition.• Core is a
combination of 1-1/2” (3.75cm) polyethylene over 2-1/2” (6.25cm)
polyurethane foam• Cover is 18 oz. knife coated vinyl fabric• 2”
(50mm) VELCRO® brand fasteners
416-160 Pommel Horse Mat System 12’ x 13’
x 4”
(3.6M x 3.9M x 10cm) (not shown) |
|
